Open End “STANDARD” Blind Rivets
General purpose rivet available in a wide range of materials and head styles. Suitable for applications with normal load bearing requirements. By far the most commonly used style of blind rivet due to the ease of use and low initial cost.
The Countersunk or CSK head profile provides a neat and flush finish to the joint. This enables multiple layered assembly and also a safe surface without any projection.
The countersink angle of 120° ensures that this rivet is suitable for thin sheets as well.
Available in a number of material combinations.
Aluminium – Lightweight with good corrosion resistance.
Steel – Stronger than Aluminium with a “flash” coating of Zinc. Low corrosion resistance.
Stainless Steel A2 – Good Strength and excellent corrosion resistance.
Stainless Steel A4 – Good Strength and increased corrosion resistance
Copper – Relatively soft. Excellent corrosion resistance and conductivity.
Monel – The strongest blind rivet material with excellent corrosion resistance and conductivity. Also excellent high temperature suitability.
Stainless Steel – Stainless Steel – Download-Datasheet-A2-A2
Material Usage Guide
Galvanic Corrosion • When dissimilar metals come into contact in the presence of an electrolyte, a galvanic action occurs which corrodes one metal at a faster rate and the other more slowly. This phenomenon can cause major riveted joint failures and care must be taken to avoid the occurrence. The following table is a guide.
|RIVET MATERIAL↓||Aluminium||Coated Steel||Stainless Steel||Copper||Brass|
|NO||Incompatible – Avoid contact with each other|
|CARE||Use with care. Painting metals will help|
1) Select materials that are as close together as possible in the Galvanic Series Chart.
2) Provide a barrier between the two metals, such as paint, non-metallic washer or gaskets.
3) Design the fastener as the cathode so the cathodic area is small as compared to the anodic area.
4) Use a metallic finish on the fastener that is close on the chart to the mating material.